Page 1 of 1

Similarity percentages jump back to 100%

Posted: Thu Dec 01, 2005 2:54 am
by Richard
Evaluating version 2.2 Image Comparer. Last night it worked good. Today when I select the folder to compare and click Compare it resets the lower percentage of similarity back to 100. Then my results say nothing matched. Shouldn't the lower similarity percentage stay on what it was set at?

Re: Similarity percentages jump back to 100%

Posted: Thu Dec 01, 2005 3:17 pm
by bolide
Hello Richard,

Did you tried to decrease "Database limit" BEFORE the new comparison?
Did you changed "% Similarity" in the main window AFTER comparison is done?

Similarity percentages jump back to 100%

Posted: Sat Dec 03, 2005 2:01 am
by Richard
Here are the steps I use to just scan a single folder for dups when the problem occurs:

Start Image Comparer
Set similarity range from 95 to 100%
Click on Compare folders button
Add folder to scan
Set database limit to 99
Click on Compare button
Similarity range automatically changes to 100 to 100 percent. (the problem)
Creating database dialog window appears.

Quite a simple procedure. Not sure what I'm doing wrong.
Richard

Re: Similarity percentages jump back to 100%

Posted: Tue Dec 06, 2005 5:14 pm
by bolide
Strange situation. We will try to find out why it happens.
I think in your case you can set 99 to 100 similarity filter AFTER the comparison is done

Similarity % jumps back to 100%

Posted: Fri Dec 09, 2005 5:21 am
by Richard
That doesn't work either.
I cannot get past this problem. I've deleted databases, re-installed, etc.
Nothing works.

Richard